George
01-22-2007, 10:47 PM
Here are a few tips on methods of river crossing I put together. I didn't have too much of a problem with rivers during my time on the PCT, (apart from a painful fall into one, off a boulder hop) but these are methods I've used at various locations. Hope they are of interest. :)
River crossings can be deceptively hazardous. Even a very shallow swiftly flowing body of water can pack enough force to 'skittle' the unwary. If you cannot walk at the speed of a stick thrown into the river, or if the river is swift and above knee height, then it could be hazardous to cross. If a river is in flood, then wait for it to subside. If in doubt as to whether a river is safe to cross, then find an alternative route. However, if that is not possible, then here are a few tips for water crossings...
Crossing Alone
1. If possible, view the river from above to identify the shallowest and smoothest area of river
bed possible, avoiding submerged snags, boulders etc. Do not attempt a crossing if large
pieces of debris (logs, branches, etc.) are being carried downstream.
2. Keep your boots on. Wet boots are preferable to damaged ankles or feet.
Do not cross wearing long pants, these will increase resistance to the current.
Release the waist and chest strap on your pack before crossing. This way you will be able
to free yourself quickly if you find yourself in a position where your pack is snagged
and holding you down.
It's also well to remember that your pack has a certain amount of buoyancy and can serve
as a flotation device if necessary.
3. Generally, the safest area to cross will be a straight section between bends in a river. If you imagine the
river in the shape of the letter 'S' then the safest area to cross will be the middle of the 'S'
between the bends. That way, if you should lose your footing, hopefully the current will carry
you into the bank on one of the bends. Always look for the best 'run off' section of a river
that will carry you to a safe point and not into danger if you lose your footing.
4. Use a stout pole or stick about five or six feet in length as support, placing it on your upstream side
so that the current forces it into the bottom. Always keep two points of contact on the river
bed at all times and cross diagonally downstream, resisting the current much like you
would a strong wind. Take shuffling footsteps, feeling for the bottom. Try not to look down at
the flowing water as this may upset your equilibrium, look ahead for the best possible route.
Resist the temptation to grab at submerged or semi submerged rocks as this may upset
your balance.
Crossing in a party
1. Members of the party stand in line abreast, each placing their hands behind the back of the
person on either side of them and grasping the lower part of that persons pack shoulder
strap. (or clothing if no pack is worn) This will 'interlock' the party. If a pack does not have
a quick release buckle on the hip belt, then the hip belt should be left undone and
clothing grasped instead.
Enter the water parallel to the current, with the strongest member of the party in the
upstream position, this will break the flow for the others. Move with the upstream person
just slightly ahead of the next person downstream and so on down the line.
If a member of the party should break away during the crossing, the remaining members
should maintain formation and either back out, or complete the crossing before attempting
a rescue if necessary.
Ensure that important items are stowed in waterproof areas of your pack. (Plastic rubbish
bags make good pack liners)
If you lose your footing and are carried away, release your pack but hold onto it. Float with your
head upstream, this will allow you to fend off from any obstacles with your feet.
Remember, flowing water is deceptively strong. Do not view river crossings lightly.
Method for gauging the width of a river (or gorge)
1. Sight a point 'A' on the opposite bank.
2. Place a marker 'B' into the bank directly opposite.
3. Walk at right angles for a known number of paces and then place another marker 'C'
4. Continue for another equal number of paces and then place another marker 'D'
5. Turn at right angles away from the river and marker 'D' and keep moving back until your
second marker 'C' and the point 'A' on the other side of the river are in line. The distance
from here back to 'D' will give a good approximation of the width of the river/gorge.
Hope that is of interest. :)
Cheers, George
River crossings can be deceptively hazardous. Even a very shallow swiftly flowing body of water can pack enough force to 'skittle' the unwary. If you cannot walk at the speed of a stick thrown into the river, or if the river is swift and above knee height, then it could be hazardous to cross. If a river is in flood, then wait for it to subside. If in doubt as to whether a river is safe to cross, then find an alternative route. However, if that is not possible, then here are a few tips for water crossings...
Crossing Alone
1. If possible, view the river from above to identify the shallowest and smoothest area of river
bed possible, avoiding submerged snags, boulders etc. Do not attempt a crossing if large
pieces of debris (logs, branches, etc.) are being carried downstream.
2. Keep your boots on. Wet boots are preferable to damaged ankles or feet.
Do not cross wearing long pants, these will increase resistance to the current.
Release the waist and chest strap on your pack before crossing. This way you will be able
to free yourself quickly if you find yourself in a position where your pack is snagged
and holding you down.
It's also well to remember that your pack has a certain amount of buoyancy and can serve
as a flotation device if necessary.
3. Generally, the safest area to cross will be a straight section between bends in a river. If you imagine the
river in the shape of the letter 'S' then the safest area to cross will be the middle of the 'S'
between the bends. That way, if you should lose your footing, hopefully the current will carry
you into the bank on one of the bends. Always look for the best 'run off' section of a river
that will carry you to a safe point and not into danger if you lose your footing.
4. Use a stout pole or stick about five or six feet in length as support, placing it on your upstream side
so that the current forces it into the bottom. Always keep two points of contact on the river
bed at all times and cross diagonally downstream, resisting the current much like you
would a strong wind. Take shuffling footsteps, feeling for the bottom. Try not to look down at
the flowing water as this may upset your equilibrium, look ahead for the best possible route.
Resist the temptation to grab at submerged or semi submerged rocks as this may upset
your balance.
Crossing in a party
1. Members of the party stand in line abreast, each placing their hands behind the back of the
person on either side of them and grasping the lower part of that persons pack shoulder
strap. (or clothing if no pack is worn) This will 'interlock' the party. If a pack does not have
a quick release buckle on the hip belt, then the hip belt should be left undone and
clothing grasped instead.
Enter the water parallel to the current, with the strongest member of the party in the
upstream position, this will break the flow for the others. Move with the upstream person
just slightly ahead of the next person downstream and so on down the line.
If a member of the party should break away during the crossing, the remaining members
should maintain formation and either back out, or complete the crossing before attempting
a rescue if necessary.
Ensure that important items are stowed in waterproof areas of your pack. (Plastic rubbish
bags make good pack liners)
If you lose your footing and are carried away, release your pack but hold onto it. Float with your
head upstream, this will allow you to fend off from any obstacles with your feet.
Remember, flowing water is deceptively strong. Do not view river crossings lightly.
Method for gauging the width of a river (or gorge)
1. Sight a point 'A' on the opposite bank.
2. Place a marker 'B' into the bank directly opposite.
3. Walk at right angles for a known number of paces and then place another marker 'C'
4. Continue for another equal number of paces and then place another marker 'D'
5. Turn at right angles away from the river and marker 'D' and keep moving back until your
second marker 'C' and the point 'A' on the other side of the river are in line. The distance
from here back to 'D' will give a good approximation of the width of the river/gorge.
Hope that is of interest. :)
Cheers, George